| Step | | Procedure & Parts & Tools |
| 1 |
|
LOCATE THE MACHINE TOOL THAT WAS ATTACHED TO THE KEY RING OF YOUR MACHINE. THIS TOOL WILL BE USED TO OPEN THE MACHINE. IF YOU DO NOT HAVE THIS TOOL, YOU CAN USE A LONG FLAT TIP SCREWDRIVER.
|
| 2 |
|
LOCATE THE LABEL ON THE LEFT SIDE OF MACHINE (STANDING IN OPERATOR POSITION). FOLLOW THE DIRECTIONS ON THE LABEL TO OPEN THE MACHINE.
|
| 3 |
|
FOLLOWING THE DIRECTIONS ON THE LABEL, INSERT THE MACHINE TOOL INTO THE MACHINE.
|
| 4 |
|
LOCATE THE WIRE CONNECTORS ON THE SOLENOID VALVE. PULL TO DISCONNECT THE WIRES. TURN THE KEY ON AND PUSH THE SOLUTION BUTTON ON THE CONTROL PANEL.
|
| 5 |
|
INSERT THE VOLT METER LEADS INTO THE WIRE CONNECTORS. THE VOLT METER SHOULD READ 24 VOLTS. IF SOLENOID VALVE IS OKAY, REVERSE STEPS 1 THRU 4 TO REASSEMBLE THE MACHINE.
| Volt meter (True RMS capable) |
&Width=100)
|
|